Cyclades PR2000 Installationshandbuch PDF herunterladen (Seite 17)

17Chapter 4 Board and System Configuration

When frame relay is used, create and/or modify the ifcfg-pvcN file(s) for the PVC to be used with

the PC300 installed. The parameters in the ifcfg-pvcN file are as follows:

Parameter Description Value

DEVICE The device name assigned by the computer to

this PVC.

pvcN

MASTERDEV The interface with which this PVC is

associated

hdlcN (this N is not necessarily the same

as the N in the device name pvcN above)

DLCI The DLC number assigned to this PVC

IPADDR The local IP address of this PVC.

POINTOPOINT The remote IP address of the PVC.

ONBOOT Determines whether or not the interface is

activated when the computer is booted.

yes or no

STEP THREE

If the driver was installed as a module (see explanation in chapter 3), the file

/etc/conf.modules

(or

/etc/modules.conf

, depending on the distribution) must be modified. Add the line

alias hdlcN pc300

anywhere in the file.

STEP FOUR

After creating and editing the ifcfg-hdlcN file(s) for the port(s),

execute the command

pc300up hdlcN

to activate each interface.

The following command can be executed to deactivate the interface:

pc300down hdlcN

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Keine Kommentare

Cyclades PR2000 Installationshandbuch Seite 17